Watermelon SWAPS
Craft foam can be turned into just about anything if your good with scissors and use the right glue. Throw in a pattern and you're good to go with my various foam SWAPS.
For these SWAPS you will need: 
  • Colored Craft Foam
  • Scissors 
  • Black pen or fine tipped indelible marker
  • Safety Pins
  • Raindrop hand punch
  • Craft Glue
  • the Pattern file
    How to use my patterns
Assembly Instructions
1. Download the document and print the pattern on cardstock. Cut it out carefully to use as a tracing template. 
2. Trace the pattern on the craft foam with care. 

3. Cut out the pieces. The patterns are circles, which yu will then cut in half to make the slices. 

4. Using a raindrop hand punch, cut drops from black craft foam. If you don't have a raindrop punch, you can either use a circle or make little snippets of foam for seeds. 

5. Glue the flesh of the watermelon (red) to the peel (green), lining them up as shown above. 

6.  Glue the 'seeds' to the watermelon. 

7. Just slip a pin through the foam, or glue a flat backed pin to the back! 


For more of this type of SWAPS, try the Craft Foam Page
You Might also Like: